• Home
  • Product
  • Gallery
  • Principal
  • Contact Us
  • Galaxy Group
Scientific & Technical Product | Products


Digital Logic Circuit Experiments Training Kit with Automated PC Utility of Digital
Controlled Pattern Generation and Data Measurement.


  • Digital Logic Circuit Experiment with Universal Bread Board
  • Sine Wave and Triangle Wave via Waveform Generator Included
  • Variable Clock Generator Included, Range in 0 to 1MHz
  • USB DAQ interface to PC for 8 bit Data Pattern Generation and Data Measurements
  • Several External Signal Input & Selection Functionality with Button and Toggle Devices
  • Power Status Monitoring with Voltage and Ampere Analog Panel


  • Uses Bread Board composed of 3 Terminal Strips and 4 Bus Strips to perform diverse experiments at a time
  • Sine Wave and Triangle Wave Waveform Generator makes the frequency between 0~999Hz enabled to logic circuit composed by a user
  • Variable Clock Generator with range 0Hz~1MHz. Provides 1Hz clock and 10Hz clock as basic clocks and separately creates Clock with the range of 0Hz~1MHz to use 3 kinds of clocks simultaneously for a circuit composed by a user
  • Supports Interface between PC and Equipment via DAQ. Receives 8 bit Signal created from PC to use implemented logic circuit and conversely sends 8 bit Signal outputted from the implemented logic circuit to PC to analyze the signal on the monitor
  • Supports an experiment interlocking with various input devices. Uses Logic Signal to input Rising edge and Falling edge signal and uses Single Pulse button to enable Pulse signal with 1ms. And provides 12 Toggle Switches and 2 Button Switches for a user to control the signal
  • Supports Display experiment using LED and 7-Segment. LED. LED is Green High-brightness Diffusible type for distinguished visibility. 7-Segment controls 2 devices from BCD input. And Slide Switch can change the input conditions of Anode and Cathode selectively depending on the experiment of display methods
  • Supports Piezo and Buzzer as signal output devices. Signal Control Experiments using Variable Resistor with 500k􀇮 and 10k􀇮. Embedded Piezo and Buzzer can be used to generate the sound.
  • Voltage and Ampere measurement Analog Panel support to measure Volt(0v~15v) and Ampere(0A~1A).





+5V(Embedded Current Protection Circuit), +9V. +15V, -15V

Frequency Generator

0Hz ~ 1MHz

Display : 7-Segment(3 digit) & LED(Sine Wave, Triangle Wave)

Control : Rotary SW(3) & Toggle SW(1)

Waveform Generator

0Hz ~ 999Hz

Display : 7-Segment(3 digit) & LED(Sine Wave, Triangle Wave)

Control : Rotary SW(3) & Toggle SW(1)


8bit Input, 8bit Output, PC Data Interface


5mm High brightness LED 8ea


BCD Input 7-segment(Anode, Cathode) 2ea

Logic Signal

Rising Edge & Falling Edge 1ea

Single Pulse

1ms Single Pulse Generator 1ea

Toggle Switch

User Toggle Switch 12ea

Button Switch

User Button Switch 3ea

Variable Resistor

10k􀊃1ea, 500k􀊃 1ea


Input 5V ,Output 2.4kHz


Input range 20Hz ~ 22kHz

Volt Meter

DC 0 ~ 15V 1ea

Ampere Meter

DC 0 ~ 1A 1ea

Bread Board

Terminal Strip 3ea & Bus Strip 4ea

Board Size

Base : 336 x 273 (mm)

Bread board : 167 x 146 (mm)

* An example, max size varies according to spine width.
Fastbind Casematic™ system: patented.
Design and specifications are subject to change without prior notice.


  • Manual
  • USB Cable(AB) 1ea
  • Jumper Wire : 1 Set
  • 220V Power Cable 1ea